Incident sheet · /infrastructure
- System
- Infrastructure & Cloud
- Filed
- Read
- 3 min · 624 words
- Severity
- Routine
FAA halts Juniper router rollout after 18,000-flight ground stop
The FAA paused its Juniper router rollout after one Arkansas device overloaded comms, cancelling 18,000-plus flights. Only 69 of 3,648 conversions are live.

Event log
- A nearly five-hour ground stop cancelled more than 18,000 flights, the longest US shutdown since 9/11
- A Juniper router installed by L3Harris in El Dorado, Arkansas, generated 1,000 connection attempts every four to five seconds
- 17 of 22 FAA en route air traffic control centres were affected
- Only 69 of 3,648 planned router conversions are operational
- 13 Democratic senators demanded testing, independent validation, failover and rollback procedures before deployment resumes
The US Federal Aviation Administration has immediately paused deployment of additional Juniper routers pending further testing, after a nationwide ground stop last week cancelled more than 18,000 flights — the longest US aviation shutdown since the September 11, 2001 attacks.
The decision follows pressure from 13 Democratic senators on the Senate Commerce Committee, led by Washington state's Maria Cantwell, who urged the FAA to stop the rollout until safety and reliability questions are answered.
The grounding disrupted travel plans for hundreds of thousands of passengers and lasted nearly five hours.
What actually broke?
US Transportation Secretary Sean Duffy said the trigger was a single Juniper router, installed by contractor L3Harris Technologies at an FAA radio communications site in El Dorado, Arkansas. That device flooded a key government communications system with connection attempts at a rate of roughly 1,000 every four to five seconds.
Put plainly: the new router hammered the network with connection requests fast enough to destabilise it.
The overload destabilised aircraft communications and radar feeds. It affected 17 of the 22 FAA en route air traffic control centres that were still running old routers, and that cascade forced the ground stop, according to Duffy.
The FAA said its initial investigation points to two possible locations where the data overload occurred: El Dorado and a radar site in Amarillo, Texas. Duffy noted L3Harris had replaced the Amarillo router three weeks earlier.
Once the data "inconsistencies" appeared, L3Harris ultimately blocked those two locations, which stabilised the network. As a precaution, the FAA also disabled the broadcasting function on the new routers and on 60 other routers across the system.
The takeaway: one replacement device in one remote facility was enough to knock out most of the country's en route traffic control infrastructure.
How far along was the rollout?
The migration is large. In a letter, the senators spelled out the scale, citing information from L3Harris:
- The copper-to-fiber transition involves converting 3,648 routers to Juniper devices
- 400 devices have been installed to date
- Only 69 of those are operational
That leaves roughly 3,250 conversions still to go — more than eight times the number installed so far — before the network reaches its target state.
"With thousands of conversions remaining, FAA must address outstanding safety and reliability concerns before expanding installation," the senators wrote.
In short: the project is barely 11 percent complete, and its future is now on hold.
What do lawmakers want before the rollout resumes?
The senators set out clear conditions. "Deployment should resume after the FAA demonstrates the devices' readiness for safe deployment through improved operational testing, independent validation, verified fail over capability, and rollback procedures," they wrote.
That checklist amounts to four gates: better operational testing, independent validation, proven failover, and a working rollback path — none of which, in the senators' view, prevented last week's failure.
"Congress expects clear, fact-based answers about the root cause of this disruption and why existing safeguards failed to prevent it," they wrote.
Duffy said it remains unclear why the router triggered the overload, and he is scheduled to brief senators on Tuesday, US time.
Where does the investigation stand?
Testing of the two routers is now taking place at an L3Harris lab in Florida. The government has blamed the mass flight shutdown on the L3Harris router installation.
L3Harris, which did not immediately comment, has previously said it is cooperating with the official investigation into what went wrong.
For enterprise readers, the lesson is structural: a hardware refresh on a live, safety-critical network proceeded without verified failover or rollback, and a single misbehaving node propagated failure across 17 of 22 regional centres.
The rollout stays paused until the FAA can prove the devices are safe to deploy.
via itnews.com.au (Source)
More from Amara Osei
Show full bio
Correspondent covering regulation, policy and their impact on enterprise information technology and the leaders who run at CIO Monitor.
188 articles
The newsroom digest
One email a day with the stories that matter. No noise.
Cross-references
- FBI Joins FAA Probe of Router Behind 4-Hour Nationwide Ground Stop
- FAA grounds all US flights after telecom failure at 22 control centers
- FAA Halts All US Flights Citing Telecommunications Outage
- FAA Router Overload from L3Harris Cable Upgrade Grounded 8,200+ Flights
- No coordinated attack behind outage wave, DNI tells Congress